1. Check that there is a green light on the “I/o” board.|
2. Check the motor operation by direct coupling the motor to the main power supply.
3. If the red LED on the I/o board is bright red and the motor is not running.
4. If the motor still does not run check the motor brushes.
5. If a US Digital encoder is fitted, check the connection of the plugs from the encoder to the I/o board. This is the grey cable that goes between the top of the motor to the I/o board.
Remove this cable and clean the pins on both the encoder and the I/o board and reconnect.
If this condition persists call your dealer or Taege Engineering Ltd.